Differences

This shows you the differences between two versions of the page.

--- calibration [2019/07/19 16:09] – visentin
+++ calibration [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
-====== Initialization - Zero reference ======
-The ''Calibration Sequence'' can be started by triggering the safety event ''doCalibrating''. This can be done by pressing the red button until this lights up. Press and hold the red button for 2 seconds, this will trigger the Safety Event ''doCalibrating''. When finished with calibrating, press the red button once again. Press the green button to get back in normal operation mode.
-==== Mechanical Limits of the Axis Motors ====
-The axis motors have mechanical upper and lower limits.
-^Upper limit^Upper limit detail^Lower limit^
-|{{:delta:zero_ref_ntb.jpg?400|}}|{{:delta:zero_ref_ntb_2.jpg?300|Upper limit calculation detail}}| {{:delta:motor-axis-calculation-lower-n.jpg?300|}}|
-|Upper limit calculation shown below| Upper limit calculation detail |Lower limit of the Axis Motor |
-L = 17.5 \\
-B = 15   \\
-s = 4    \\
-The upper limit can be calculated as follows:
-\\ \\
-//(1) tan(β) = sin(β)/cos(β) = (B-y)/L// \\
-//(2) cos(β) = s/y// \\
-\\
-Substitute (2) into (1) to get: \\
-\\
-//(3) L*sin(β)-B*cos(β)=-s// \\
-\\
-Using following trigonometric formulas in (3):
-\\ \\
-//(4) t = tan(β/2) // \\
-//(5) sin(β) = 2*tan(β/2)/(1+tan^2(β/2) // \\
-//(6) sin(β) = (1-tan^2(β/2)/(1+tan^2(β/2) // \\
-\\
-Leads to:
-\\ \\
-//(7) (s+B)*t^2 + 2*L*t + (s-B) = 0// \\
-\\
-Solutions are:
-\\
-// t1 = 0.2736 -> β = 30.6°// \\
-// t2 = -2.1157 (neg. solution)// \\
-\\
-Hence, the maximum angle the axis can turn is // 90° + β ≅ 120°//.\\
-\\
-Lower limit of the Axis Motor measured on the Delta robot, γ is about 5°.
-==== Mechanical Limits of the Tool Center Point Motor ====
-The TCP rotation is also limited by two metall pins. The maximum turn angle is calculated as follows:\\
-{{ :delta:tcp-limit.jpg?300 |TCP limit}}
-//sin(γ/2) = r/R//\\
-//γ=2*arcsin(r/R)= 0.0600 (rad) = 3.438°//\\
-\\
-That is the value for one side. The other side is identical, so the maximum turn angle is\\
-\\
-//β = 2*PI - 2 * 0.06 = 6.16 (rad) ≅ 353°//.