Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision |
| hal [2019/11/30 21:16] – [Configure the Encoder Inputs] graf | hal [2020/02/20 11:52] – [Configure the Outputs for the Motors] ursgraf |
|---|
| |
| ===== Configure the Outputs for the Motors ===== | ===== Configure the Outputs for the Motors ===== |
| If you want to run a motor with EEROS you need to define a //Peripheral Output// with the respective ''signalId'' used in the HAL configuration file. As you can see in the configuration file //HwConfigBBBlue.json// the ''subdevice2'' comprises the analog outputs for the 4 motors. In the EEROS application for the Delta roboter you can set a motor voltage of -8.0V to 8.0V. The HAL gets this values and wraps it to match the values of the robotics_cape_library which then runs the motors with the desired voltage. | If you want to run a motor with EEROS you need to define a //Peripheral Output// with the respective ''signalId'' used in the HAL configuration file. As you can see in the configuration file //HwConfigBBBlue.json// the ''subdevice2'' comprises the analog outputs for the motors. In the EEROS application for the Delta roboter you can set a motor voltage of -8.0V to 8.0V. The HAL gets this values and wraps it to match the values of the robotics_cape_library which then runs the motors with the desired voltage. |
| {{ :delta:software:hal-motor.jpg?350 |HAL-Configuration for the motors}} | {{ :delta:software:hal-motor.jpg?350 |HAL-Configuration for the motors}} |
| |
