User Tools

Site Tools


motors_init

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
motors_init [2019/12/01 08:31] – [Mechanical Limits of the Axis Motors - Upper limit] grafmotors_init [2020/02/27 18:43] ursgraf
Line 6: Line 6:
  
  
-|{{:delta:zero_ref_ntb.jpg?350|}}|{{:delta:zero_ref_ntb_2.jpg?250|Upper limit calculation detail}}| +|{{:delta:software:zero_ref_ntb.jpg?350|}}|{{:delta:software:zero_ref_ntb_2.jpg?250|Upper limit calculation detail}}| 
 |Upper limit calculation shown below| Upper limit calculation detail | |Upper limit calculation shown below| Upper limit calculation detail |
  
Line 34: Line 34:
 ==== Mechanical Limits of the Axis Motors - Lower limit ==== ==== Mechanical Limits of the Axis Motors - Lower limit ====
  
-{{:delta:motor-axis-calculation-lower-n.jpg?300|}}+{{:delta:software:motor-axis-calculation-lower-n.jpg?300|}}
  
 For the lower limit of the Axis Motor the angle γ is measured to be about 5°. For the lower limit of the Axis Motor the angle γ is measured to be about 5°.
  
  
motors_init.txt · Last modified: 2021/06/11 16:19 by ursgraf