User Tools

Site Tools


motors_init

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
motors_init [2019/12/01 08:31]
graf [Mechanical Limits of the Axis Motors - Upper limit]
motors_init [2020/02/27 18:43] (current)
ursgraf
Line 6: Line 6:
  
  
-|{{:​delta:​zero_ref_ntb.jpg?​350|}}|{{:​delta:​zero_ref_ntb_2.jpg?​250|Upper limit calculation detail}}| ​+|{{:delta:software:​zero_ref_ntb.jpg?​350|}}|{{:​delta:software:​zero_ref_ntb_2.jpg?​250|Upper limit calculation detail}}| ​
 |Upper limit calculation shown below| Upper limit calculation detail | |Upper limit calculation shown below| Upper limit calculation detail |
  
Line 34: Line 34:
 ==== Mechanical Limits of the Axis Motors - Lower limit ==== ==== Mechanical Limits of the Axis Motors - Lower limit ====
  
-{{:​delta:​motor-axis-calculation-lower-n.jpg?​300|}}+{{:delta:software:​motor-axis-calculation-lower-n.jpg?​300|}}
  
 For the lower limit of the Axis Motor the angle γ is measured to be about 5°. For the lower limit of the Axis Motor the angle γ is measured to be about 5°.
  
  
motors_init.txt · Last modified: 2020/02/27 18:43 by ursgraf