Differences

This shows you the differences between two versions of the page.

--- ntb:control_system [2021/10/22 12:05] – ursgraf
+++ ntb:control_system [2023/05/25 14:43] (current) – ursgraf
@@ Line 1: / Line 1: @@
 ====== Control System ======
+The ntb version has a motor in the tool point center (TCP). Positive direction is clockwise when seen from the top.
 The control system is the same as [[..::control_system|]], except that it does not have the 'circle planner ' block.
 It is only possible to switch between mouse motion and automatic motion, where the automatic motions is the sorting and shuffling of the three blocks.
-Also, it has a forth axis and the ''AxisVector'' has four degrees.
+Also, it has a forth axis for turning the TCP and the ''AxisVector'' has four degrees.
 {{:delta:ntb:software:controlsystem_ntb.png
 |Control System of the Delta Roboter}}
-When detecting blocks, the TCP moves down for a first step. Then it switches to force mode. In that mode, it moves forward by applying a constant force. This force should be as low as possible to avoid loud clicking when making contact with a block while it must be high enough to overcome friction.
+When detecting blocks, the TCP moves down in a first step. Then it switches to force mode. In that mode, it moves forward by applying a constant force. This force should be as low as possible to avoid loud clicking when making contact with a block while it must be high enough to overcome friction.