Differences

This shows you the differences between two versions of the page.

--- ntb:hal [2020/02/20 11:56] – [Configure the Encoder Inputs] ursgraf
+++ ntb:hal [2020/02/27 18:59] (current) – [Encoders on the Tool Center Point Motor] ursgraf
@@ Line 4: / Line 4: @@
-==== Encoders on the Axis Motors ====
-The axis motors are equipped with a gear with the ratio of //76:1// and with an encoder //ieh2-4096//, which provides //4096 lines per revolution//. The quadrature decoder function, which counts the encoder ticks, delivers 4 counts per line. \\
-To account for this in the configuration file of the HAL, we add three blocks. These blocks mirror the physical behavior of the decoder, encoder, and gear.\\
-{{ :delta:software:hal-ieh2.jpg?500 |HAL config for ieh2 encoder}}
-The total scale will be calculated by the HAL as (76 * 4096 * 4) / 2π.
 ==== Encoders on the Tool Center Point Motor ====
 The TCP motor are equipped with a gear with the ratio of //120:1// and with an encoder //hem3-256w//, which provides //256 lines per revolution//. The quadrature decoder function, which counts the encoder ticks, delivers 4 counts per line. \\
-{{ :delta:software:hal-hem3.jpg?500 |HAL config for HEM3 encoder}}
+{{ :delta:ntb:software:hal-hem3.jpg?500 |HAL config for HEM3 encoder}}
 The total scale will be calculated by the HAL as (120 * 256 * 4) / 2π.