control_system
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
control_system [2023/05/11 17:01] – [Motor Model] ursgraf | control_system [2023/05/11 17:13] (current) – [Motor Model] ursgraf | ||
---|---|---|---|
Line 40: | Line 40: | ||
==== Motor Model==== | ==== Motor Model==== | ||
- | As our board cannot only control voltages fed to each motor, we must use a motor model to calculate these voltages. The block 'Motor Model' gets the actual speed and the calculated torque as input, and outputs the desired voltage for each motor. | + | As our board cannot only control voltages fed to each motor, we must use a motor model to calculate these voltages. The block 'Motor Model' gets the actual speed and the calculated torque as input, and outputs the desired voltage for each motor. |
+ | < | ||
+ | U = kM * w + I * RA + dI/dt * L | ||
+ | </ | ||
+ | with I = M / kM and dI/dt * L beeing very small with our motors and accounting for the gear i we get | ||
+ | < | ||
+ | U = kM * w * i + M * RA / (kM * i) | ||
+ | </ | ||
==== Outputs ==== | ==== Outputs ==== | ||
The drive signals to the motor are of type '' | The drive signals to the motor are of type '' | ||
Line 47: | Line 53: | ||
eeros:: | eeros:: | ||
</ | </ | ||
+ | |||
+ | The block ' |
control_system.1683817275.txt.gz · Last modified: 2023/05/11 17:01 by ursgraf