ntb:motors_init
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
ntb:motors_init [2023/05/25 14:46] – [Mechanical Limits of the Tool Center Point Motor] ursgraf | ntb:motors_init [2023/05/25 14:46] – ursgraf | ||
---|---|---|---|
Line 16: | Line 16: | ||
Zero position is chosen in the middle of the free range. | Zero position is chosen in the middle of the free range. | ||
+ | :!: | ||
IMPORTANT Make sure that the TCP is properly fixed on the motor shaft. Two tiny screws must be carefully tightened. | IMPORTANT Make sure that the TCP is properly fixed on the motor shaft. Two tiny screws must be carefully tightened. |
ntb/motors_init.txt · Last modified: 2023/05/25 14:47 by ursgraf