ntb:motors_init
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
ntb:motors_init [2023/05/25 14:46] – [Mechanical Limits of the Tool Center Point Motor] ursgraf | ntb:motors_init [2023/05/25 14:47] (current) – [Mechanical Limits of the Tool Center Point Motor] ursgraf | ||
---|---|---|---|
Line 17: | Line 17: | ||
Zero position is chosen in the middle of the free range. | Zero position is chosen in the middle of the free range. | ||
- | IMPORTANT | + | :!: Make sure that the TCP is properly fixed on the motor shaft. Two tiny screws must be carefully tightened. |
ntb/motors_init.txt · Last modified: 2023/05/25 14:47 by ursgraf