This is an old revision of the document!
Program Execution and User Interface
Starting the application on the Delta robot will do a homing first, see Homing. After homing the Delta is in system ready mode which is indicated by the green and blue LED.
If you press the green button, the Delta starts its Auto Moving Sequence. In between shuffling and sorting the blocks you can take control by using a mouse, see Mouse Sequence. By moving the mouse you can move the tool center point (TCP). You can raise and lower the TCP by scrolling. By pressing the left or right mouse button you enable the electromagnet. Releasing the mouse button will disable it. If you do not perform any action with the mouse for 2 seconds, the robot will start it's auto sequence operating mode again.
Press the blue button to stop the Auto Moving Sequence or Mouse Sequence. This will stop the current sequence, raise the TCP and put it back to it's homing position. The robot is again in system ready mode.
Press the red button in case of an emergency and the red LED lights up. In this case you have to press the green button to continue. The Delta will repeat its homing and go to system ready mode.
If you press the blue button 3 times in the system ready mode, the robot will move to it's parking position and power down. When pressing the green and blue button together in the system ready mode, the Delta can be calibrated.
Buttons
The robot is equipped with three buttons: red, blue, green. You can use the buttons for following actions:
| Action | Button | Available in state |
|---|---|---|
| Start 'Auto Moving' | green | 'System Ready' |
| Stop 'Auto Moving' | blue | 'Auto Moving' or 'Mouse Control' |
| Emergency stop | red | all |
| Exit 'Emergency' | green | 'Emergency' |
| Stop the application | blue (3 times) | 'System Ready' |
| Start calibration | blue & green | 'System Ready' |
Following actions are possible:
| Action | Button |
|---|---|
| Trigger an emergency | red |
| Initialize robot after an emergency | green |
| Park the robot, stop application and shut down | blue button three times or for three seconds |
Each of the three buttons contain a LED giving the buttons its color.
- The red emergency button lights up as soon as the robot goes into emergency state. It will switch off upon leaving this state.
- The green and blue LED indicates that the associated button can be pressed, see above.
Mouse
- Moving the mouse on the desk will move the robot in XY direction
- Scrolling will move z-axis up and down in the vertical direction
- If a magnet is mounted on the TCP, pressing the left or right button will turn on the magnet